LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Door Lock Systems & Door Handles) >> Repair Instructions >> Rear Compartment Lid Latch Striker Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Compartment Lid Lock Striker & Bolts
    GM318885Courtesy of GENERAL MOTORS CORP.
  1. Position the rear compartment lid lock striker to the rear compartment body panel.
  2. Install the bolts in the center hole in the rear compartment lid lock striker under the rear bumper fascia above the impact bar to the rear body panel.
  3. Partially tighten the bolt to allow for adjustment of the rear compartment lid lock striker.
  4. Close the rear compartment lid and adjust the rear compartment lid striker as required.
    5. NOTE: Refer to Fastener Notice .
  5. Install the other rear compartment lid lock striker bolts to under the rear bumper fascia above the impact bar to the rear body panel.

    Tighten:  Tighten the bolts to 16 N.m (12 lb ft).

  6. Install the bolts to the lock striker in the rear compartment.

    Tighten:  Tighten the bolts to 16 N.m (12 lb ft).

  7. Install the rear bumper fascia. Refer to Rear Bumper Fascia Replacement .
  8. Install the rear compartment trim. Refer to Rear Compartment Trim Panel Replacement .
  9. Close the rear compartment.
scientia non olet · About LEMON Manuals