LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Mobile Telephone and Navigation Antenna Coaxial Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Radio Antenna Module & Antenna Cable
    GM1203709Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement .
  2. Remove the rear seat back. Refer to Rear Seat Back Replacement (Folding) or Rear Seat Back Replacement (Non-folding) .
  3. Remove the lower pillar trim panel. Refer to Lower Pillar Garnish Molding Replacement .
  4. Remove the left rear quarter lower panel. Refer to Rear Quarter Lower Trim Panel Replacement .
  5. Remove the left rear upper quarter trim panel. Refer to Rear Quarter Upper Trim Panel Replacement .
  6. Lower the rear of the headliner. Refer to Headlining Trim Panel Replacement .
  7. Disconnect the antenna cable (2) from the radio antenna module.
  8. Remove the lower center pillar trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
  9. Adjust the carpet for access to the antenna cable (1) and body harness as required. Refer to Front Floor Panel Carpet Replacement .
    10. Fig 2: View Of Left Instrument Panel Outer Trim Cover
    GM929251Courtesy of GENERAL MOTORS CORP.
  10. Remove the left instrument panel (I/P) compartment access hole cover.
  11. Disconnect the antenna cable from the antenna extension cable.
  12. Cut off the visible ends of the antenna cable from the wiring harness in the following locations:
    • The kick panel area
    • The rear header area
scientia non olet · About LEMON Manuals