LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Blower Motor Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right side instrument panel (I/P) insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
    2. Fig 1: View Of Electrical Connector & Blower Control Module
    GM1262636Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector from the blower control module.
  3. Remove the 2 heat stakes from the blower control module using a small chisel.
  4. Remove the blower control module.
scientia non olet · About LEMON Manuals