LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Blower Motor Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the blower control module.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 2 new screws in the pre-drilled holes to the side of the heat stakes in the blower control module and the HVAC module assembly.

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

    3. Fig 1: View Of Electrical Connector & Blower Control Module
    GM1262636Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the blower control module.
  4. Install the right side I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
  5. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals