LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Passenger Presence System Replacement - Front >> Installation Procedures

Installation Procedures

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating SIR ECU & Wiring Harness
    GM1282185Courtesy of GENERAL MOTORS CORP.
  1. Position the passenger presence system to the seat making sure to route the wiring correctly.
  2. Insert the wiring harness attachment clips into the cushion frame.
    3. NOTE: Refer to Fastener Notice .
  3. Install the three ECU retaining bolts that secure the ECU to the bracket.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  4. Install the ECU bracket retaining bolts (3) that secure the unit to the seat cushion frame.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    5. Fig 2: Locating Electronic Control Unit (ECU) Module
    GM1282550Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connectors to the ECU module and install the CPA.
  6. Install the seat cushion trim cover. Refer to Front Seat Cushion Cover Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
  8. Re-zero the passenger presence system. Refer to Passenger Presence System Rezeroing .
  9. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals