Conditions for Clearing the DTC

The DTC becomes history when then conditions for setting the DTC are no longer present.
The history DTC clears after 40 malfunction free warm-up cycles.
The PCM receives the clear code command from the scan tool.

DTC P0520

Step	Action	Yes	No
Schematic Reference: Instrument Cluster Schematics
1	Did you perform the Instrument Cluster Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Instrument Cluster
2	Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Engine Oil Pressure Switch parameter in the powertrain control module (PCM) Engine Data 2 data list. Does the Engine Oil Pressure Switch parameter display Low?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Turn OFF the ignition. Disconnect the engine oil pressure switch. Connect a fused jumper wire between the oil pressure switch signal circuit and a good ground. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Engine Oil Pressure Switch parameter in the PCM Engine Data 2 data list. Does the Engine Oil Pressure Switch parameter display Low?	Go to Step 5	Go to Step 4
4	Test the signal circuit of the engine oil pressure switch for an open or a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 10	Go to Step 7
5	Test the ground circuit of the engine oil pressure switch for an open or a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 10	Go to Step 6
6	Inspect for poor connections at the harness connector of the engine oil pressure switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 10	Go to Step 8
7	Inspect for poor connections at the harness connector of the PCM. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 10	Go to Step 9
8	Replace the engine oil pressure switch. Refer to Engine Oil Pressure Sensor and/or Switch Replacement or Engine Oil Pressure Sensor and/or Switch Replacement . Did you complete the replacement?	Go to Step 10	-
9	IMPORTANT: Program the replacement PCM. Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement in Engine Controls - 3.1L or to Powertrain Control Module (PCM) Replacement in Engine Control - 3.8L.Did you complete the replacement?	Go to Step 10	-
10	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Does the DTC reset?	System OK	Go to Step 2