Chime Inoperative
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
Chime Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Audible Warnings Schematics | |||
| 1 | Did you review the operation and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Instrument Panel, Gages and Console |
| 2 | Open the driver door. Does the door ajar indicator illuminate in the DIC when the driver door is opened? |
Go to Step 3 | Go to Door Ajar Indicator Malfunction in Doors |
| 3 |
|
Go to Step 4 | Go to Step 18 |
| 4 |
|
Go to Step 5 | Go to Step 6 |
| 5 |
|
Go to Step 7 | Go to Step 8 |
| 6 | Test the park lamp switch signal circuit for an open or for a high resistance. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 23 | Go to Step 15 |
| 7 |
|
Go to Step 23 | Go to Special Tools in Seat Belts |
| 8 | Test the key in ignition ground circuit for an open or for a high resistance. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 23 | Go to Step 10 |
| 9 |
|
Go to Step 12 | Go to Step 11 |
| 10 | Test the key in ignition signal circuit for an open, for a short to battery voltage, or for a high resistance. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 23 | Go to Step 13 |
| 11 | Test the DIC signal circuit for an open or for a high resistance. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 23 | Go to Step 14 |
| 12 | Test the vehicle speed signal circuit for an open. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 23 | Go to Step 16 |
| 13 | Inspect for poor connections at the harness connector of the ignition switch. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 23 | Go to Step 21 |
| 14 | Inspect for poor connections at the harness connector of the DIC. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 23 | Go to Step 22 |
| 15 | Inspect for poor connections at the harness connector of the headlamp switch. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 23 | Go to Step 19 |
| 16 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 23 | Go to Step 20 |
| 17 | Repair the open in the seat belt switch signal circuit. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 23 | - |
| 18 | Repair the open in the suspected turn signal circuit. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 23 | - |
| 19 | Replace the headlamp switch. Refer to Multifunction, Turn Signal Switch Replacement
in Steering Wheel and Column. Did you complete the replacement? |
Go to Step 23 | - |
| 20 | Replace the BCM. Refer to Body Control Module Replacement
in Body Control Systems. Did you complete the replacement? |
Go to Step 23 | - |
| 21 | Replace the ignition switch. Refer to Ignition Switch Replacement Did you complete the replacement? |
Go to Step 23 | - |
| 22 | Replace the DIC. Refer to Driver Information Center Replacement . Did you complete the replacement? |
Go to Step 23 | - |
| 23 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |