Turn Signal Lamps and/or Indicators Always On or Flashing
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
Turn Signal Lamps and/or Indicators Always On or Flashing
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List in Wiring Systems |
|||
| 1 | Did you perform the Lighting System Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Lighting Systems |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 11 | Go to Step 4 |
| 4 | Are all four of the turn signals lamps flashing? | Go to Hazard Lamps Always On | Go to Step 5 |
| 5 | Is only one lamp on at all times? | Go to Step 6 | Go to Step 7 |
| 6 | Test for a short to battery positive voltage in the turn signal voltage circuit. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 12 | Go to Step 9 |
| 7 | Disconnect the multifunction turn signal switch. Do the turn signal lamps turn off? |
Go to Step 10 | Go to Step 8 |
| 8 | Test for a short to ground in the illuminated turn signal switch circuit. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 12 | Go to Step 9 |
| 9 |
IMPORTANT:
After replacing the body control module (BCM), perform the setup procedure. Refer to Body Control Module (BCM) Programming/RPO Configuration
in Body Control System. Replace the BCM. Refer to Body Control Module Replacement
in Body Control System.Did you complete the replacement? |
Go to Step 12 | - |
| 10 | Replace the multifunction turn signal switch. Refer to Multifunction, Turn Signal Switch Replacement
in Steering Wheel and Column. Did you complete the replacement? |
Go to Step 12 | - |
| 11 | Replace the IPC. Refer to Instrument Panel Cluster (IPC) Replacement
in Instrument Panel, Gages and Console. Did you complete the repair? |
Go to Step 12 | - |
| 12 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |