LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2001 >> Century Limited >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Mechanical - 3.1L V6 (VINJ) >> Removal & Installation >> Cylinder Head >> Installation (Left & Right)

Installation (Left & Right)

  1. Clean cylinder head bolt threads and cylinder block holes. Install gasket onto cylinder block with THIS SIDE UP mark up (if equipped). Ensure all holes align with cylinder block. Install cylinder head. Apply GM Sealant (1052080) to head bolt threads.
  2. Tighten NEW cylinder head bolts to specification in sequence. See TORQUE SPECIFICATIONS . See Fig 1. To complete installation, reverse removal procedure. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING .
Fig 1: Cylinder Head Bolt Tightening Sequence
GM826677Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals