Refitting oil pan

• Position the oil pan (2)  .
• Tighten screws (1)  crosswise.

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the rear axle differential on special tool 0 496 009 (33 5 200) and secure it using special tool 0 496 080 (33 5 206)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the adapter on the rear axle differential.

Courtesy of BMW OF NORTH AMERICA, INC.

• Replace screws (1)  for adapter (2)  .

  Parts:  Screws

• Tighten the screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to REPLACING THE LEFT AND RIGHT RADIAL SHAFT SEAL .
• Refer to INSTALLING REAR AXLE DIFFERENTIAL .
• Refer to INSTALLING THE HEAT SHIELD .
• Refer to PREPARING THE SPECIAL TOOL .
• Refer to LIFTING REAR AXLE SUPPORT .
• Refer to INSTALLING RIGHT OUTPUT SHAFT .
• Refer to FASTENING THE RIGHT AND LEFT OUTPUT SHAFTS ON THE REAR AXLE DIFFERENTIAL .
• Refer to ATTACHING THE BOTTOM WISHBONE AND THE CAMBER CONTROL ARM TO THE RIGHT WHEEL CARRIER .
• Refer to RELIEVING TENSION ON THE RIGHT COIL SPRING .
• Refer to INSTALLING THE RIGHT REAR BRAKE PADS .
• Refer to ADDING REAR DIFFERENTIAL FLUID .
• Refer to SECURING THE PROPELLER SHAFT ON THE REAR AXLE DIFFERENTIAL .
• Refer to INSTALLING THE REAR HEAT SHIELD .
• Refer to INSTALLING THE LEFT AND RIGHT THRUST FIELDS AND THE TORSION STRUT .
• Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
• Refer to INSTALLING EXHAUST SYSTEM .
• Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
• Refer to SECURING THE CABLE TO THE REAR AXLE SUPPORT .
• Refer to FASTENING THE RIGHT OUTPUT SHAFT ON THE WHEEL BEARING .
• Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
• Refer to PLACING THE BRAKE PADS ON THE BRAKE DISK/PUTTING THEM INTO OPERATION .
• Refer to MEASURING THE RIDE HEIGHT OF REAR AXLE AND ADJUSTING THE NORMAL POSITION .
• Refer to TIGHTENING THE SCREW CONNECTION TO THE SHOCK ABSORBER AND THE WHEEL CARRIER .
• Refer to PERFORMING CHASSIS ALIGNMENT CHECK .
• Refer to TIGHTENING THE SCREW CONNECTIONS TO THE WHEEL CARRIER .