Installing left and right wiper arm
NOTE:
TECHNICAL INFORMATION
The wiper system must be in the zero position.
After installing the cowl cover and before installing the wiper arms:
Operate wiper system 1x to ensure wiper system is in the correct installation position.
The wiper system must be in the zero position.
After installing the cowl cover and before installing the wiper arms:
Operate wiper system 1x to ensure wiper system is in the correct installation position.
- Connect the wiper arm (3).
- Correctly position the wiper arm (2) in relation to the window edge (1).TECHNICAL DATA SPECIFICATION
Distance from window pane edge to wiper blade Wiper arm right (A) 57.5 ± 5 mm Wiper arm left (B) 63.3 ± 4 mm - Tighten nut (2).TIGHTENING TORQUES SPECIFICATION
Windshield wiper arm Combination hexagon nut tightening torque 35 Nm - Connect the protective cap (1).
- Feed the washer fluid hose (1) into the guide of the windshield panel and connection at the separation point.