Install the control unit for the contactless trunk opening

Position control unit (2) and clip into latch mechanism (arrow).
Insert and connect the connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Position brace for the rear bumper (2) on the support.
Install the expanding rivet (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Clip in the cable clips (2) on the inside of the brace for the rear bumper (3).
Tighten the screws (1).

TIGHTENING TORQUES SPECIFICATION

Rear bumper cover mount to support for rear bumper
Hexagon screw for thermoplastic	Tightening torque	2.6 Nm

G14645660

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE REAR BUMPER COVER .
Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
Refer to INSTALLING THE LEFT AND RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (PARTIALLY REMOVED) .
Refer to INSTALLING LOADING EDGE TRIM .
Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .