Installing the operating facility in the center console

Position the operating facility in the (2) center console (3) and connect and lock the associated connector.
Tighten down screws (1).

TIGHTENING TORQUES SPECIFICATION

GWS to center console trim
screw	Tightening torque	1.8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Activate electrical system

NOTE: TECHNICAL INFORMATION
Follow the vehicle-specific instructions described in the additional information .

Activate the vehicle electrical system as described in the additional information.

Courtesy of BMW OF NORTH AMERICA, INC.

Activating the 48 V electrical system

Precondition

Ignition is switched off.

NOTE: RISK OF DAMAGE
Damage to the 48-V battery
If a 48-V battery that is disconnected from the electrical system is activated, the battery electronics will be damaged.

Only ever activate the 48 V electrical system when the 48 V battery is fully connected up.

Raise the battery ground cable.
Remove special tool 2 452 007 .

Courtesy of BMW OF NORTH AMERICA, INC.
Release the negative battery cable of the 48-V battery from the attachment.
Position the negative battery cable of the 48-V battery on the negative battery terminal.

Tighten nut.

TIGHTENING TORQUES SPECIFICATION

Negative battery cable to 48-V battery
Nut M8	tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the connector of the CAN bus and lock it.
Clip in clip.

Courtesy of BMW OF NORTH AMERICA, INC.
Activate the 48 V electrical system by closing the hood.

Activation is automatic.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE CENTER CONSOLE TRIM .
Refer to INSTALLING TRIM IN STORAGE COMPARTMENT OF CENTER ARMREST .
Refer to ACTIVATING ELECTRICAL SYSTEM .