Socket housing 42-, 43-, 46-pin, Hybrid System MQS/MPQ
Special tools required:
61 0 312
Special tools required:
- 61 0 312
Manufactured by AMP: The following bushing housings without single conductor seal can be fitted in the socket housings:
- MQS (Micro Quadlock System)
- MPQ, width 2.8 mm (Micro Power Quadlock)
- MPQ, width 5.2 mm (Micro Power Quadlock)
Open secondary locks (1) on socket housing.
Press back safety catch of MQS contacts (2) with special tool 61 0 312 61 1 134 and pull out cable with contact.
Press back safety catch of MPQ contacts (3) with screwdriver and pull out cable with contact.
Installation note:
Bend open safety catch of contacts gently before inserting into connector housing.
For installation of contacts, observe chamber numbers on reverse side of socket housing.