Remove the air distribution damper motor on the right (M7a)
NOTE:
TECHNICAL INFORMATION
The controller drive must be readdressed after replacement.
Addressing can only be carried out with the diagnosis system.
The controller drive must be readdressed after replacement.
Addressing can only be carried out with the diagnosis system.
Preliminary work
- Refer to ENTER THE INSTALLATION POSITION OF THE DAMPER MOTOR .
- Refer to REMOVING RIGHT FOOTWELL TRIM .
- Refer to VEHICLES WITH AIRBAG MODULE: REMOVING KNEE AIRBAG .
- Refer to REMOVING THE BLOWER FOR THE HEATING AND AIR-CONDITIONING UNIT .
- Unlock plug connection (1) and disconnect.
- Unscrew the screws (2) and remove the right air distribution flap motor (3) .
- Replacing controller drive of air distribution flap, right (after vehicle diagnosis) (M7a) »