Check the components of the steering
Check
Desired state
- There is no play between the tie rod joint (1) and tie rod arm (2) .
Result
» There is play.
Measure
- Eliminate possible defects for a separate charge after discussion with the customer.
Check
- Check Bellows and sleeves for damage (e.g. cracks and holes) and tightness.
- Check bellows for missing retaining straps.
Result
» Damage or leaks.
Measure
- Eliminate possible defects for a separate charge after discussion with the customer.
Follow-up work
- Refer to ADDING THE COOLANT LEVEL AND CHECKING THE COOLANT COMPOSITION .
- Refer to CHECKING ENGINE COMPARTMENT FROM ABOVE FOR LEAKS .
- Refer to TOP OFF THE WASHER FLUID FOR THE WASHER SYSTEM .
- Refer to PROGRAMMING WHEEL ELECTRONICS (ONLY WHILE USING TIRE PRESSURE MONITOR SA2VB) .
- Refer to PERFORM THE CBS RESET .
- Refer to CHECKING FOR TRAFFIC SAFETY AND PERFORMING TEST DRIVE .