LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2025 >> 230i >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Bag Restraint Systems) >> Removal & Installation >> Driver-Side Air Bag Module >> Removal & Installation (4-spoke Steering Wheel)

Removal & Installation (4-spoke Steering Wheel)

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 BMW M3, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2005 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove screw from lower steering column trim and remove trim. Pull Orange electrical connector off steering column and disconnect. Using T30 Torx bit with long shank, remove air bag module Torx screws from rear of steering wheel. Lift up air bag module to disconnect wiring connector from rear of module. Put air bag module in a secure area with trim pad (air bag) facing upward.
  3. To install, reverse removal procedure. Tighten air bag module Torx screws to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals