LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2025 >> 230i >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Air Bag Restraint Systems) >> Removal & Installation >> Driver-Side Air Bag Module >> Removal & Installation (3-spoke Steering Wheel)

Removal & Installation (3-spoke Steering Wheel)

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 BMW M3, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2005 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Insert screwdriver through opening on rear side of steering wheel. See Fig 1. Press down on spring lock and pull out air bag. See Fig 2. Repeat process on opposite side. Pull out air bag and disconnect electrical connectors. Open locks on plugs and disconnect plug connections. Remove air bag. Put air bag module in a secure area with trim pad (air bag) facing upward.
  3. To install, insert air bag hooks into spring locks and press into steering wheel. Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
Fig 1: Inserting Screwdriver Behind Steering Wheel
G99C22725Courtesy of BMW OF NORTH AMERICA, INC.
Fig 2: Releasing Air Bag Spring Lock
G99E22727Courtesy of BMW OF NORTH AMERICA, INC.