Adjusting track (eccentric screw already renewed)
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Turn eccentric screw 2 to set the track to the setpoint value.
- Tighten the nut (1) in the NORMAL POSITION .
NOTE:
Counter support the eccentric screw.
TIGHTENING TORQUE SPECIFICATIONS
| Lower rear wishbone to wheel carrier | ||
| M12 Replace eccentric screw, eccentric washer and nut. | Tightening torque | 100 Nm |
Follow-up work
- Refer to ADJUSTING THE FRONT RADAR SENSOR (FRS) .