Install the Front Light Electronics
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: 61 35... NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION .
- Loosen screws (1).
- Pull the Frontal Light Electronics (2) out of the headlight.
- Unlock and disconnect connector (1).
- Remove the Front Light Electronics (2).
- Check the seal (3) on the Frontal Light Electronics (2) for damage and replace if necessary.
- Connect plug (1)
.
Check
- After locking: The plug connection must be checked for correct, firm fit.
Result
» The firm fit is not correct.
Measure
- Disconnect the connectors and check the locking mechanism for mechanical damage.
Measure
- Replace the damaged plug components.
Measure
- Fit, insert and lock the connector at a right angle to the direction of insertion.
Measure
- Check correct firm fit again.
- Position the front light electronics (2) in the headlight.
- Tighten the screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Frontal Light Electronics (FLE) | ||
|---|---|---|
| PT-SCREW 40x12 | tightening torque | 1.5 Nm |
Follow-up work