Installing the cushion support (M CFRP bucket seat)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
- Protect working area.
- Handle tools and components carefully.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Carefully clip the seat cushion support (1)
into the detents of the support tube (2)
in the arrow direction.
- Tighten the screws (1) on the cushion support (2)
TIGHTENING TORQUES SPECIFICATION
| Upholstered support to the backrest frame | ||
|---|---|---|
| Oval-head screw with collar | Tightening torque | 6.5 Nm |
Follow-up work
- Refer to INSTALLING BACKREST WIDTH ADJUSTMENT WITH VALVE (M CFRP BUCKET SEAT) .
- Refer to INSTALLING THE BACKREST COVERING WITH THE CUSHION (M CFRP BUCKET SEAT) .
- Refer to INSTALLING THE REAR APERTURE TRIM (M CFRP BUCKET SEAT) .
- Refer to INSTALLING THE FRONT APERTURE TRIM (M CFRP BUCKET SEAT) .
- Refer to INSTALLING THE EMBLEM IN THE BACKREST OF THE FRONT SEAT (M CFRP BUCKET SEAT) .
- Refer to INSTALLING THE INSERTING FOR THE HEAD RESTRAINT (M CFRP BUCKET SEAT) .
- Refer to INSTALLING THE INNER COVER ON THE FRONT SEAT .
- Refer to INSTALLING OUTER COVER ON FRONT SEAT .
- Refer to INSTALLING DRIVER'S SEAT .