Install the intake pipe
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the O-rings of the intake pipe (2)
.
Parts: O-rings
- Completely feed in the intake pipe (2) and position correctly.
- Close the holder (arrow).
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Refrigerant line to air conditioning condenser/connecting piece | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
- Place the intake pipe (2) on the air conditioning compressor (3) .
- Tighten the screw (1) from the side of the wheel well on the intake pipe (2) .
TIGHTENING TORQUES SPECIFICATION
| Refrigerant line on air conditioning compressor | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
Follow-up work
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to INSTALLING FAN COWL WITH ELECTRIC MOTOR .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
- Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .
- Refer to EVACUATING AND CHARGING CONDITIONING .