Installing tie rod end

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Screw tie rod end onto the tie rod up to dimension (A), which was determined before removal.

NOTE: If necessary, hold the tie rod with an open-end wrench for counter support.

Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Tie rod end to tie rod
M10	tightening torque	32 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Position the tie rod end (2) on the swivel bearing.
Replace nut (1).
Parts: Nut

Tighten nut (1).

NOTE: If necessary, counter-hold at the Torx socket.

TIGHTENING TORQUE SPECIFICATIONS

Tie rod end to swivel bearing
M14 Replace nut.	Tightening torque	165 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to MOUNTING THE WHEEL .
Refer to PERFORMING CHASSIS ALIGNMENT CHECK .