Installing the pressure sensor on the right intake plenum
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Position the pressure sensor (2).
- Pressure sensor (2) must lock audibly on retaining tab (3).
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Pressure sensor | ||
| screw | Tightening torque | 3 Nm |
- Connect and lock connector (1) on the right pressure sensor.
- Connect and lock connector (2) on the Valvetronic servomotor.
Follow-up work
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING MOUNTING FOR DME MASTER CONTROL MODULE SUPPORT .
- Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
- Refer to INSTALLING ACOUSTIC COVER .
- Installing the cover panel of the master DME control unit.
- Position the cover of the master DME control unit (1)
- Engage the cover panel of the master DME control unit (1) downwards with the clamps (2) and the guide pins (3) in the carrier plate of the DME.
- Refer to CONNECTING BATTERY GROUND LEAD .