Installing/replacing the right rail pressure sensor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Precondition
High-pressure rail is removed.
- Replace the rail pressure sensor (2)
.
Parts: Rail pressure sensor
- Screw in the rail pressure sensor (2) in the high-pressure rail and tighten it.
TIGHTENING TORQUES SPECIFICATION
| Rail pressure sensor to rail | ||
| Rail pressure sensor M10 | Tightening torque | 35 Nm |
- Un-clamp the rail on the lug (1) .
Follow-up work
- Refer to INSTALLING RAIL OF CYLINDER BANK 1 .
- Refer to INSTALLING IGNITION COILS OF CYLINDER BANK 1 .
- Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
- Installing the cover panel of the master DME control unit.
- Position the cover of the master DME control unit (1)
- Engage the cover panel of the master DME control unit (1) downwards with the clamps (2) and the guide pins (3) in the carrier plate of the DME.
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING BATTERY GROUND LEAD .