52 26 301 Removing and installing / replacing actuating mechanism for left rear seat backrest (through-loading system)

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 325Ci, 2005 BMW 325xi, 2005 BMW 325i, 2005 BMW 325Ci, and 2004 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove and install lock for rear seat backrest (through-loading system), refer to 52 26 309 REMOVING AND INSTALLING/REPLACING LOCK FOR REAR SEAT BACKREST (THROUGH-LOADING SYSTEM), LEFT .

For saloon/sedan only:

Loosen screws (1).

Fig 1: Unlocking Catch

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock catch (2) and at same time unclip mechanism (3) towards bottom.

Unclip Bowden cable from mounting (4).

Installation:

Catches (1) of mechanism (3) must not be damaged.

Fig 2: Identifying Catches Of Mechanism
Courtesy of BMW OF NORTH AMERICA, INC.

Bowden cable (2) must be engaged correctly in mechanism (3).

For Coupe only:

Loosen screws (1).

Fig 3: Unclipping Bowden Cable From Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock catch (2) to middle of car and at same time unclip mechanism (3) towards bottom.

Unclip Bowden cable from mounting (4).

Installation:

Catches (1) and (2) of mechanism (3) must not be damaged.

Fig 4: Identifying Catches Of Mechanism
Courtesy of BMW OF NORTH AMERICA, INC.

Bowden cable (4) must be engaged correctly in mechanism (3).