Install support for bumper cover at front bottom
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Thread in the support for the bumper cover at front bottom (2) and position.
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATION
Front bottom bumper cover support to deformation element Combination oval-head machine screw Tightening torque 10 Nm
Follow-up work
- Refer to INSTALLING THE BOTTOM AUTOMATIC AIR FLAP CONTROL .
- Refer to IF INSTALLED: INSTALLING THE FRONT RADAR SENSOR (FRS) WITH THE BRACKET .
- Refer to INSTALLING THE FRONT BUMPER COVER .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to INSTALLING FRONT WHEEL ARCH TRIM PANEL ON THE LEFT AND RIGHT (PARTIALLY REMOVED) .
- Refer to INSTALLING THE COVER FOR CENTRAL ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .