Installing front brake caliper (vehicles with high brake)
- Install the brake caliper in the arrow direction.
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATION
Brake caliper/brake anchor plate at front swivel bearing M12
Replace screw.tightening torque 130 Nm - Fit and tighten brake hose (1) on brake caliper.
If necessary, grip at knurling (2) .
TIGHTENING TORQUE SPECIFICATIONBrake hose to brake caliper, front tightening torque 17 Nm - Make sure the brake hose is not twisted and resting on components attached to the body.
- If necessary, hook the brake hose in the holder (3)
.
Follow-up work
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE (VEHICLES WITH HIGH BRAKE) .
- Refer to INSTALLING FRONT PADS (VEHICLES WITH HIGH BRAKE) .
- Refer to ADHESION OF BRAKE PADS TO BRAKE PISTONS .
- Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (VEHICLES WITH HIGH BRAKE) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to COMMISSIONING OR BEDDING IN (BRAKE) OF NEW BRAKE PADS AND DISCS (VEHICLES WITH HIGH BRAKE) .