Install front brake caliper (vehicles with 17-inch low brake)

• Fit and tighten brake hose (1) on brake caliper.

  If necessary, grip at knurling (2)  .

  TIGHTENING TORQUE SPECIFICATION
  
  

  Brake hose to brake caliper, front
  tightening torque	17 Nm

• Make sure the brake hose is not  twisted and resting on components attached to the body.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to REMOVING THE BRAKE PEDAL TENSIONER .
• Refer to GREASE THE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER USING BRAKE PAD PASTE (17 INCH BRAKE) .
• Refer to INSTALLING FRONT BRAKE PADS (17 INCH BRAKE) .
• Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR (17 INCH BRAKE) .
• Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
• Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to COMMISSIONING/BEDDING IN (BRAKE) NEW BRAKE PADS AND BRAKE DISCS .