Install adapter
NOTE:
TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position.
Incorrect assembly is possible. Ensure correct installation position.
- Position the adapter on the rear axle differential.
- Replace screws (1) and (2) for adapter (3).
Parts: Screws
- Screw in screws (1) and (2) a few turns.
- Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Adapter of front rear axle differential to rear axle differential | ||
| M12 Replace screw. | Tightening torque | 120 Nm |
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Adapter of rear axle differential to rear axle support | ||
| M12 Replace screw. | Tightening torque Angle of rotation |
100 Nm 90° |
- Lower special tool 0 496 009 (33 5 200) using special tool 2 219 012 and keep it aside.
- Position ground cable (2) on the rear axle differential.
- Tighten nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Ground strap on rear axle differential | ||
| M12 | Tightening Torque | 19 Nm |
Follow-up work
- Refer to SECURING THE PROPELLER SHAFT ON THE REAR AXLE DIFFERENTIAL .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING THE LEFT THRUST FIELD .
- Refer to INSTALLING TANK COVER .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .