Installing the left thrust field
- Position the left thrust field (4).
- Replace screws (1) and (3).
Parts: Screws
- Screw in the screws (1) and (3) for a few rotations.
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to body | ||
| M8 | Tightening torque | 28 Nm |
- Tighten the screws (3).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to outer body | ||
| M10 Replace screw. | Tightening torque Angle of rotation |
56 Nm 90° |
- Replace nut (2).
Parts: Nut
- Tighten nut (2).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to rear axle support | ||
| M10 Replace nut. | Tightening torque Angle of rotation |
56 Nm 90° |
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Torsion strut to thrust field | ||
| M8x27 Replace screw. | Tightening torque | 28 Nm |
- Replace screws (1).
Parts: Screws
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to door sill | ||
| M12 Replace screw. | Tightening torque Angle of rotation |
100 Nm 90° |
- Tighten the nuts (1) and screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Undershield | ||
| screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |
Follow-up work
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING TANK COVER .