Installing the control unit holder

• Make sure that the control unit bracket (1) is inserted below correctly into the mount (2)

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the control unit holder (2) and install
• Tighten down screws (1)
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Control unit bracket at the shock tower
  Hexagon screw	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the cable bracket (3) in the arrow direction and install it

  The locks (2) must engage audibly

• Secure the clamp (1)

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the cable clip (1) with the control unit holder (2) and lock it

  The lock (arrow) must engage audibly

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and install the connector (2)

  The locks (1) must engage audibly

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock
• The connectors (1) must engage audibly

Courtesy of BMW OF NORTH AMERICA, INC.

• Secure clamp (arrow)
• Feed in and install the connector (4) on the control unit bracket (5)

  The connector (4) must engage audibly

• Connect connectors (3) and lock

  The connector (3) must engage audibly

• Feed in and install the connector (2) on the control unit bracket (5)

  The connector (2) must engage audibly

• Connect connectors (1) and lock

The connector (1) must engage audibly

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE CONTROL UNIT HOLDER .
• Refer to PARTIALLY INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to INSTALLING THE DME CONTROL UNIT .
• Refer to INSTALLING THE COVER FOR THE DME CONTROL UNIT .
• Refer to INSTALLING THE STRUT BRACE .
• Refer to INSTALLING CENTER FIREWALL LOWER PART .
• Refer to INSTALLING THE CENTER COWL UPPER PART .
• Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to RECONNECTING ALL BATTERY GROUND LEADS .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
• Refer to INSTALLING TRANSMISSION MOUNTING BRACKET (ALL-WHEEL DRIVE VEHICLE) .
• Refer to INSTALLING THE TRANSMISSION BEARING SUPPORT .
• Refer to FASTENING THE PROP SHAFT (PARTIALLY REMOVED) .
• Refer to INSTALLING FRONT HEAT SHIELD .
• Refer to INSTALLING THE REAR HEAT SHIELD .
• Refer to INSTALLING THE LEFT THRUST FIELD .
• Refer to INSTALLING TANK COVER .
• Refer to INSTALLING EXHAUST SYSTEM .
• Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING THE LEFT AND RIGHT FRONT UNDERSHIELD .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING THE FRONT SPOILER .