Installing the control unit holder

• Make sure that the control unit bracket (1) is inserted below correctly into the mount (2)

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in the control unit holder (2) and install
• Tighten down screws (1)
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Control unit bracket at the shock tower
  Hexagon screw	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the cable bracket (3) in the arrow direction and install it

  The locks (2) must engage audibly

• Secure the clamp (1)

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the cable clip (1) with the control unit holder (2) and lock it

  The lock (arrow) must engage audibly

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and install the connector (2)

  The locks (1) must engage audibly

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock
• The connectors (1) must engage audibly

Courtesy of BMW OF NORTH AMERICA, INC.

• Secure clamp (arrow)
• Feed in and install the connector (4) on the control unit bracket (5)

  The connector (4) must engage audibly

• Connect connectors (3) and lock

  The connector (3) must engage audibly

• Feed in and install the connector (2) on the control unit bracket (5)

  The connector (2) must engage audibly

• Connect connectors (1) and lock

The connector (1) must engage audibly

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PARTIALLY INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to INSTALLING THE DME CONTROL UNIT .
• Refer to INSTALLING THE COVER FOR THE DME CONTROL UNIT .
• Refer to INSTALLING THE STRUT BRACE .
• Refer to RECONNECTING ALL BATTERY GROUND LEADS .