Removing the connecting bracket from the exhaust turbocharger for the cylinders 4 to 6
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to REMOVING THE FRONT-END STRUT .
- Refer to REMOVING THE RIGHT INTAKE FILTER HOUSING (FRONT-END STRUT REMOVED) .
- Refer to REMOVING CLEAN AIR PIPE CYLINDERS 4-6 .
- Refer to PARTIALLY REMOVING THE COOLANT EXPANSION TANK OF THE HIGH-TEMPERATURE COOLANT CIRCUIT .
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
- Keep all the standard tools ready:
Number Description 1 Commercially available reversible ratchet (1/4) 2 Extension (1/4) 3 Swiveling extension (1/4) 4 External Torx E8 - Loosen screws (1).
- Feed out the connecting bracket (2) for cylinders 4 to 6 and remove it.