Remove all special tools
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Prohibited reuse of used parts that have been removed to flush the refrigerant circuit.
Contamination of the refrigerant circuit, damage to the refrigerant circuit. Replace the following parts:
Prohibited reuse of used parts that have been removed to flush the refrigerant circuit.
Contamination of the refrigerant circuit, damage to the refrigerant circuit. Replace the following parts:
- Air conditioning compressor
- Expansion valve
NOTE:
TECHNICAL INFORMATION
If the refrigerant circuit has been flushed, it is not necessary to adjust the amount of refrigerant oil when a new air conditioning compressor is installed.
If the refrigerant circuit has been flushed, it is not necessary to adjust the amount of refrigerant oil when a new air conditioning compressor is installed.
NOTE:
TECHNICAL INFORMATION
Once the flushing is complete, remove all the special tools just before the installation of the new parts.
Once the flushing is complete, remove all the special tools just before the installation of the new parts.
Follow-up work
- Refer to INSTALLING EXPANSION VALVE .
- Refer to CONNECTING THE REFRIGERANT LINE TO THE EXPANSION VALVE .
- Refer to INSTALLING AIR CONDITIONING COMPRESSOR .
- Refer to INSTALLING THE BELT TENSIONER .
- Refer to INSTALLING DRIVE BELT .
- Refer to FASTENING ANTI-ROLL BAR ON FRONT AXLE SUPPORT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to SECURING THE WIRING HARNESS FOR THE EPS ON THE FRONT AXLE SUPPORT .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING FAN COWL WITH ELECTRIC MOTOR .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE LEFT .
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING THE CENTER COWL UPPER PART .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING COOLANT EXPANSION TANK .
- Refer to INSTALLING HOLDER OF THE DME CONTROL UNIT FOR CYLINDERS 5 TO 8 .
- Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Installing the rear right engine compartment cover.
Remove the battery cover .
NOTE: The following step(s) must be performed if the listed component(s) is/are installed.- Remove the special tool 2 452 007 from the battery.
- Install the cover (2).
- Lock the lock (1).
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to CONNECTING BATTERY GROUND LEAD .
- Refer to EVACUATING AND CHARGING CONDITIONING .
- Refer to RUNNING IN THE NEW AIR CONDITIONING COMPRESSOR .