Installing fan cowl with electric motor
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the fan cowl (1) downwards to the coolant hoses.
- Clip in the hose support (2) to the fan cowl (1).
- F90 only:
Insert the front underbody protection (1).
- Slide the front underbody protection (1) slightly backwards and insert it under the thrust field (2).
- Tighten all bolts (arrows).
TIGHTENING TORQUES SPECIFICATION
| Underbody protection | ||
| screw | Tightening torque | 3 Nm |
- F91, F92, F93 only:
Insert the front underbody protection (1).
- Slide the front underbody protection (1) slightly backwards and insert it under the thrust field (2).
- Tighten all bolts (arrows).
TIGHTENING TORQUES SPECIFICATION
| Underbody protection | ||
| screw | Tightening torque | 3 Nm |
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Fan cowl with electric motor | ||
| screw | Tightening torque | 2.8 Nm |
- Clip in and secure wiring harness mountings (1).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Fan cowl with electric motor | ||
| screw | Tightening torque | 2.8 Nm |
- Connect plug connection (2) and lock.
Follow-up work
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Installing the cover panel of the master DME control unit.
- Position the cover of the master DME control unit (1)
- Engage the cover panel of the master DME control unit (1) downwards with the clamps (2) and the guide pins (3) in the carrier plate of the DME.
- Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .