Install brake caliper in the rear
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Fit and tighten brake hose (2) on brake caliper.
TIGHTENING TORQUES SPECIFICATION
| Brake hose to brake caliper, rear | ||
| tightening torque | 24 Nm | |
- Hook the brake hose into the holder (1) .
NOTE:
RISK OF DAMAGE
Incorrect routing of the brake hose.
If the brake hose is twisted or in contact with surrounding components, it can be damaged and cause the brake system to fail.
Incorrect routing of the brake hose.
If the brake hose is twisted or in contact with surrounding components, it can be damaged and cause the brake system to fail.
- Do not install the brake hose in a twisted position.
- Insert the brake hose (1) into the body side holder.
- Make sure the retaining spring (2) fits correctly!
- Attach and tighten the union screw (3) .
TIGHTENING TORQUES SPECIFICATION
| Brake pipe screw connection/Union screws | ||
| tightening torque | 17 Nm | |
Follow-up work
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to GREASING BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to INSTALLING THE REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING REAR LEFT OR RIGHT WHEEL .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSHING AND VENTING THE REAR AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to STARTING OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND BLADES (REAR BRAKE) .