Disconnect the bleeder unit for the brake fluid

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: RISK OF DAMAGE
Paint damage.
Mechanical or chemical action may lead to paint damage.

Cover up working area with specified covering material only.

Switch off bleeder unit (1) and remove it from the brake fluid expansion tank.
Check the brake fluid level and, if necessary, adjust it to the maximum mark.

Courtesy of BMW OF NORTH AMERICA, INC.

Check the seal (1) on the sealing cap for damage and replace if necessary.
Mount the sealing cap on the brake fluid expansion tank.

Courtesy of BMW OF NORTH AMERICA, INC.

Install the cover of the engine compartment on the rear left

Install the cover (2).

Lock the lock (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to PERFORMING THE CBS RESET .
Refer to IF INSTALLED: CHECKING THE GAS PRESSURE SPRINGS FOR HOOD (ONLY FOR VERSIONS WITH ACTIVE PEDESTRIAN PROTECTION (SA8TF)) .