Installing the headlining (lowered)

Precondition 

The front seats have been fully adjusted towards the bottom.

The front seat backrests have been fully adjusted towards the rear.

The rear seat backrest is folded down toward the front.

• Install the counter support (1) of the sun visors in the headlining and fasten with the clamps (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check if clips (1) are present on the headlining and check them for damage.

  Damaged or missing clips (1) must be replaced.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the headlining (1) with the help of an auxiliary person onto the respective edge protection.
• Clip in headlining (1) on the clips (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Headlining to C-pillar
  Oval-head screw	Tightening torque	1.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE COVERS FOR THE INTERIOR MIRRORS .
• Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
• Refer to INSTALLING THE LEFT AND RIGHT HANDS-FREE MICROPHONE .
• Refer to INSTALLING FRONT VANITY MIRROR LIGHT .
• Refer to INSTALLING THE COUNTER SUPPORT FOR THE SUN VISOR .
• Refer to INSTALLING THE SUN VISOR .
• Refer to INSTALLING A-PILLAR TRIM PANEL .
• Refer to INSTALLING INTERIOR ROOF LIGHT .
• Refer to INSTALLING C-PILLAR TRIM PANEL .
• Refer to INSTALLING B-PILLAR TRIM PANEL .
• Refer to INSTALLING 3RD BRAKE LIGHT TRIM .
• Refer to INSTALLING REAR TRIM PANEL .
• Refer to INSTALLING THE SEAT BELT FINISHER STRIP .
• Refer to INSTALLING THE INNER DOOR SILL COVER STRIP .
• Refer to INSTALLING BACKREST SIDE SECTION .
• Refer to INSTALLING THE REAR SEAT .