Installing the left knock sensors
- Clip in the wiring harness mounting (1).
- Connect connectors (2) and lock.
- Connect connectors (2) and lock.
- Clip in the wiring harness mounting in the area (1).
Follow-up work
- Refer to INSTALLING REINFORCEMENT STRUT .
- Refer to SECURING THE TRANSMISSION OIL COOLING BRACKET .
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH TRIM (DOOR SILL) .
- Refer to FOR REUSING: CHECKING THE GEARING OF THE OUTPUT SHAFT AND REPLACING THE SNAP RING .
- Refer to REPLACING THE LEFT RADIAL SHAFT SEAL .
- Refer to INSTALLING LEFT OUTPUT SHAFT .
- Refer to CHECK/ADD FRONT AXLE TRANSMISSION OIL .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING SPRING SUSPENSION STRUT .
- Refer to FASTENING THE WISHBONE TO THE TOP OF THE SWIVEL BEARING .
- Refer to FASTENING THE BRAKE HOSE AND THE CABLE .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
- Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
- Refer to ATTACHING THE FRONT LEFT WHEEL .