Replacing the left radial shaft seal

WARNING: Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!

Observe safety instructions on raising the vehicle using a vehicle hoist.
For additional information see: 00... RAISING THE VEHICLE WITH A VEHICLE LIFT .

Preliminary work

Refer to REMOVING THE FRONT LEFT WHEEL .
Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
Refer to REMOVING THE COVER OF THE STEERING ASSEMBLY .
Refer to RELEASING THE BRAKE HOSE AND CABLE .
Refer to DETACHING THE UPPER WISHBONE FROM THE SWIVEL BEARING .
Refer to SECURING THE SWIVEL BEARING .
Refer to REMOVING THE SPRING STRUT HOLDER .
Refer to REMOVE THRUST FIELD .
Refer to REMOVE LEFT OUTPUT SHAFT .

NOTE: TECHNICAL INFORMATION
Radial shaft seal ring are equipped with an installation protection ring. The installation protection ring is used to protect the sealing lip when installing the output shaft.

Remove the radial shaft seal

Pull out radial shaft seal with the aid of special tools 0 490 466 (00 5 010) and 0 495 597 (24 2 354) .

Courtesy of BMW OF NORTH AMERICA, INC.
Replace radial shaft seal at front.
Parts: Radial shaft seal
Remove the assembly protection ring (1) from the radial shaft sealing ring (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Install the radial shaft seal
Coat the housing of the sheet metal flange of the radial shaft seal with the BMW approved front differential fluid.
Drive in the radial shaft seal to the stop using the special tool 0 493 539 (31 5 130) .
Remove special tool 0 493 539 (31 5 130) .

Courtesy of BMW OF NORTH AMERICA, INC.
Reinstall installation protection ring (1) in radial shaft seal (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to FOR REUSING: CHECKING THE GEARING OF THE OUTPUT SHAFT AND REPLACING THE SNAP RING .
Refer to INSTALLING LEFT OUTPUT SHAFT .
Refer to CHECK/ADD FRONT AXLE TRANSMISSION OIL .
Refer to INSTALL THE STIFFENING PLATE .
Refer to INSTALL SPRING SUSPENSION STRUT .
Refer to FASTENING THE WISHBONE TO THE TOP OF THE SWIVEL BEARING .
Refer to FASTENING THE BRAKE HOSE AND THE CABLE .
Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
Refer to ATTACHING THE FRONT LEFT WHEEL .