Removing the trim panel for the storage shelf
NOTE:
RISK OF DAMAGE
Damage of high-quality surfaces.
Plastic wedges can damage high-quality surfaces.
Damage of high-quality surfaces.
Plastic wedges can damage high-quality surfaces.
- Protect surfaces from damage.
Preliminary work
- Refer to REMOVING REAR SEAT BENCH .
- Refer to REMOVING LEFT AND RIGHT BACKREST SIDE SECTION .
- Refer to REMOVING RIGHT C-PILLAR TRIM PANEL LEFT AND RIGHT .
- Refer to REMOVING SIDE TRIM PANEL, REAR LEFT AND RIGHT .
NOTE:
Perform the steps on the left and right side.
- Release the screw (1) from the rear end fitting (2).
- Feed out the rear end fitting (2) from the body.NOTE: Perform the steps on the left and right side.
- Unclip the cover (1) to the front.
- Unclip the outer belt feed trim (2) starting from the front and remove it.
- Release the expanding rivet (1).
- Unlock and disconnect the plug connections under the trim panel (2). Lift the trim panel (2) for that.
- Release the wiring harness with all holders from trim panel (2).
- Remove the trim panel (2) to the front and feed out the seat belts (3).