Remove side trim panel, rear left and right
NOTE:
Description is for left component only. Procedure on the right side is identical.
Remove rear side trim panel
Removing the front strap fitting
- Unclip cover cap (1) .
- Loosen screw (2)
.
- Pull out sleeve (1) from cover (2) of strap fitting (3) .
- Unclip cover (2)
of strap fitting (3)
from strap fitting (3)
.
Removing seat-belt assistant hand
NOTE: To provide a better overview: Schematic diagram with partially hidden components. - Feed out the seat-belt assistant hand (1) in direction of arrow from the seat belt extender (2) carefully.
- Feed out upper seat belt (3)
from the seat-belt assistant hand (1)
.
- Remove the cover (1)
.
- Loosen screw (1).
- Loosen screw (1).
- Release screws (1)
and (2)
.
- Unclip the side trim panel (1) with a suitable tool inwards at the clamps (2) .
- Unclip the side trim panel (1) with a suitable tool at the clips (3) .
- Carefully feed out the side trim panel (1)
at the edge protection.
- Unlock plug connections (1) and disconnect.
- Remove the side trim panel.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Remove rear side trim panel
- Unclip cover cap (1) .
- Loosen screw (2)
.
- Pull out sleeve (1) from cover (2) of strap fitting (3) .
- Unclip cover (2)
of strap fitting (3)
from strap fitting (3)
.
- Unclip the rear side trim panel (1) from clamps (2) using a suitable tool.
- Unclip the rear side trim panel (1) from clips (3) using a suitable tool.
- Release the rear side trim panel (1) from clamps (4) and guide it out from the edge protection.
- Unlock and disconnect all the plug connections on the rear side trim panel (1) of the wiring harness.
- Guide out upper seat belt (5)
.