Installing the headlining with the sliding/tilting sunroof (lowered)
Precondition
The front seats have been fully adjusted towards the bottom.
The front seat backrests are fully reclined.
The rear seat backrest is folded down toward the front.
- Install the counter support (1)
of the sun visors in the headlining and fasten with the clamps (2)
.
- Check the clips (1)
on the headlining for damage.
Defective or missing clips (1) must be replaced.
- Check the clamps (2)
along the dotted line for damage.
Defective or missing clamps (2) need to be replaced.
- Insert the headlining (1) with the help of an auxiliary person onto the respective edge protection.
- Clip in headlining (1) on the clips (2) .
- Clip the headlining (1)
in the area of the dotted line at the slide/tilt sunroof unit and the clamps (3)
.
- Clip headlining to the clips (2) .
- Tighten down screw (1)
.TIGHTENING TORQUE SPECIFICATION
Headlining on frame Oval-head screw tightening torque 1.5 Nm - Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATION
Headlining to C-pillar Oval-head screw Tightening torque 1.6 Nm
Follow-up work
- Refer to INSTALLING THE COVERS FOR THE INTERIOR MIRRORS .
- Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
- Refer to INSTALLING THE LEFT AND RIGHT HANDS-FREE MICROPHONE .
- Refer to INSTALLING FRONT VANITY MIRROR LIGHT .
- Refer to INSTALLING THE COUNTER SUPPORT FOR THE SUN VISOR .
- Refer to INSTALLING THE SUN VISOR .
- Refer to INSTALLING A-PILLAR TRIM PANEL .
- Refer to INSTALLING INTERIOR ROOF LIGHT .
- Refer to INSTALLING C-PILLAR TRIM PANEL .
- Refer to INSTALLING B-PILLAR TRIM PANEL .
- Refer to INSTALLING 3RD BRAKE LIGHT TRIM .
- Refer to INSTALLING REAR TRIM PANEL .
- Refer to INSTALLING THE SEAT BELT FINISHER STRIP .
- Refer to INSTALLING THE INNER DOOR SILL COVER STRIP .
- Refer to INSTALLING BACKREST SIDE SECTION .
- Refer to INSTALLING THE REAR SEAT .