Installing the drivetrain for the glass slide/tilt roof panel
Precondition
The glass slide/tilt roof panel is closed.
- Guide in drivetrain (3) for the glass slide/tilt roof panel and position it correctly.
- Connect and lock all connectors (2) .
- Tighten down screws (1)
.TIGHTENING TORQUES SPECIFICATION
Drive motor for panorama glass roof to body Screw tightening torque 5.5 Nm
Follow-up work
- Refer to INSTALLING 3RD BRAKE LIGHT TRIM .
- Refer to INSTALLING THE INNER DOOR SILL COVER STRIP ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT BACKREST SIDE SECTION .
- Refer to INSTALLING THE REAR SEAT .
- Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
- Refer to INITIALIZING THE GLASS SLIDE/TILT SUNROOF .
- Refer to REPLACING THE SPACER .
- Refer to REPLACEMENT: PREPARING WINDSHIELD .
- Refer to INSTALLING THE WINDSHIELD RUBBER FRAME .
- Refer to CHECKING SIGN .
- Refer to INSTALLING WINDSHIELD .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT GUTTER STRIP ON THE WINDSHIELD .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE KAFAS CAMERA .
- Refer to INSTALLING THE RAIN-LIGHT-SOLAR-CONDENSATION SENSOR (PARTIALLY REMOVED) .
- Refer to INSTALLING INTERIOR REARVIEW MIRROR .
- Refer to INSTALLING THE COVERS FOR THE INTERIOR MIRRORS .
- Refer to INSTALLING A-PILLAR TRIM PANEL, LEFT AND RIGHT .
- Refer to CALIBRATE KAFAS CAMERA .