Replacing the module bracket
Preliminary work
- Refer to REMOVING THE TRIM FOR THE EMERGENCY OPERATION .
- Refer to REMOVING THE DECORATIVE STRIP FROM THE REAR DOOR TRIM PANEL .
- Refer to REMOVING REAR DOOR TRIM .
- Refer to REMOVING MODULE BRACKET .
- Loosen screws (1) .
- Remove control unit (2) .
- Install the control unit (2) on the new module bracket.
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Control unit of the door on sound insulation | ||
|---|---|---|
| Screw | Tightening torque | 2 Nm |
Remove the loudspeaker on the rear door
- Disconnect plug connection (1) .
- Unscrew the screws (2) and remove the loudspeaker (3) .
- Replace the module bracket.
Parts: Module bracket
Install the loudspeaker on the rear door
- Position the speaker (3) .
- Replace screws (2)
.
Parts: Screws
- Tighten the screws (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Speaker to door/trim panel | ||
|---|---|---|
| Screw | Tightening torque | 2 Nm |
- Connect connector (1) .
Follow-up work
- Refer to INSTALLING MODULE BRACKET .
- Refer to INSTALLING THE REAR DOOR TRIM PANEL .
- Refer to INSTALLING THE DECORATIVE STRIP ON THE REAR DOOR TRIM PANEL .
- Refer to INSTALLING THE TRIM FOR THE EMERGENCY OPERATION .