Removing the coolant feed line for the left-hand turbocharger
Preliminary work
- Refer to REMOVING THE TOP RIGHT AND LEFT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING UPPER CROSS CONNECTION .
- Refer to REMOVING THE FRONT-END STRUT .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE INTAKE FILTER HOUSING ON THE LEFT .
- Refer to REMOVING THE LEFT UNFILTERED-AIR DUCT .
- Refer to REMOVING THE FAN COWL .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE WHEEL ARCH COVER AT THE BOTTOM FRONT LEFT AND BOTTOM RIGHT .
- Refer to DRAINING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to PARTIAL UNINSTALLATION OF THE ENGINE VENTILATION LINE OF CYLINDER BANK 2 .
- Refer to REMOVING ENGINE VENTILATION LINE OF CYLINDER BANK 2 .
- Refer to REMOVING THE LEFT INTAKE SILENCER BRACKET .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to PARTIAL UNINSTALLATION OF THE ENGINE VENTILATION LINE OF CYLINDER BANK 1 .
- Refer to REMOVING OIL FILLER NECK .
- Refer to REMOVING THE RIGHT INTAKE SILENCER BRACKET .
- Refer to REMOVING THE LOW-TEMPERATURE COOLANT EXPANSION TANK .
- Refer to REMOVING THE CROSS OF THE TRANSMISSION WIRING HARNESS .
- Refer to REMOVING LAMBDA OXYGEN SENSOR FOR THE CYLINDERS 1 TO 4 .
- Refer to REMOVING LAMBDA OXYGEN SENSOR FOR THE CYLINDERS 5 TO 8 .
- Refer to REMOVING UPPER HEAT SHIELD .
- Refer to REMOVING THE LEFT OIL FEED LINE PARTIALLY .
- Loosen hose clamp (1) .
- Loosen screw (4) .
- Loosen screw (3) .
- Remove coolant feed line (2) .