Installing the coolant feed line for the turbocharger
- Feed in the coolant feed line box (3) in a downwards direction.
- Connect and lock the coolant feed line (3).
- Snap the coolant line (2) into the holder (1).
- Slide on the coolant feed line.
- Replace the hose clamp (2).
Parts: Hose clamp
- Secure hose clamp (1).
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATION
Coolant lines to alternator M6x16 screw Tightening torque 8 Nm
Follow-up work
- Refer to INSTALLING THE CONNECTING PLATE .
- Refer to CLOSING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE LOWER LEFT FRONT WHEEL ARCH COVER .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING THE FRONT-END STRUT .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .