Installing air conditioning condenser
- Make sure the air conditioning condenser (1) at bottom is fed into the rubber mounts (2) correctly.
- Slide the coolant hose (3) slightly to the side.
- Feed in the air conditioning condenser (4) from above and position it correctly.
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Air conditioning condenser holder on body | ||
|---|---|---|
| Nut M6 | tightening torque | 8 Nm |
| M6 screw | tightening torque | 8 Nm |
- Connect and lock coolant hoses (1).
- Replace O-rings.
Parts: O-rings
- Feed in the refrigerant lines (3) under the coolant hose (4).
- Position the refrigerant lines (3) and tighten the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Refrigerant lines to air conditioning condenser/connecting piece | ||
|---|---|---|
| M6 | Tightening torque | 13 Nm |
- Clip in the hose support (1).
Follow-up work
- Refer to CONNECTING THE COOLANT LINES TO THE RADIATOR .
- Refer to CONNECTING THE COOLANT LINE TO THE AUXILIARY COOLANT PUMP .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT , and INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
- Refer to FILLING THE COOLING SYSTEM WITH THE VACUUM FILLING UNIT .
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .
- Refer to EVACUATE AND CHARGE CONDITIONING .