Install rear anti-roll bar
- Feed in the rear anti-roll bar (1) sideways.
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Position the rear anti-roll bar on the rear axle support.
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Rear anti-roll bar retainer on rear axle support | ||
| M8 Replace screws. | Tightening Torque | 28 Nm |
Follow-up work
- Refer to LIFTING REAR AXLE SUPPORT .
- Refer to LOOSENING THE LEFT AND RIGHT COIL SPRINGS .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to SECURING THE PROPELLER SHAFT ON THE REAR AXLE DIFFERENTIAL .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING THE LEFT AND RIGHT THRUST FIELDS AND THE TORSION STRUT .
- Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to SECURING THE CABLE TO THE REAR AXLE SUPPORT .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .